Ingesting Hosts

Once you have NCX Infra Controller (NICo) up and running, you can begin ingesting machines.

Prerequisites

Ensure you have the following prerequisites met before ingesting machines:

1. You have the admin-cli command available: You can compile it from sources or you can use the pre-compiled binary. Another choice is to use a containerized version.

2. You can access the NICo site using the admin-cli.

3. The NICo API service is running at IP address NICo_API_EXTERNAL. It is recommended that you add this IP address to your trusted list.

4. DHCP requests from all managed host IPMI networks have been forwarded to the NICo service running at IP address NICo_DHCP_EXTERNAL.

5. You have the following information for all hosts that need to be ingested:

   • The MAC address of the host BMC
   • The chassis serial number
   • The host BMC username (typically this is the factory default username)
   • The host BMC password (typically this is the factory default password)

Update Site

NICo requires knowledge of the desired BMC and UEFI credentials for hosts and DPUs. NICo will set these credentials on the BMC and UEFI when ingesting a host. You can use these credentials when accessing the host or DPU BMC yourself, and NICo will use these credentials for its automated processes.

The required credentials include the following:

• Host BMC Credential
• DPU BMC Credential
• Host UEFI password
• DPU UEFI password

:::{note} The following commands use the <api-url> placeholder, which is typically the following:

https://api-<ENVIRONMENT_NAME>.<SITE_DOMAIN_NAME>

:::

Update Host and DPU BMC Password

Run this command to update the desired Host and DPU BMC password:

admin-cli -c <api-url> credential add-bmc --kind=site-wide-root --password='x'

Update Host UEFI Password

Run this command to update the desired host UEFI password:

admin-cli -c <api-url> host generate-host-uefi-password

Run this command to update host uefi password:

admin-cli -c <api-url> credential add-uefi --kind=host --password='x'

Update DPU UEFI Password

TODO: Need to add this command.

Add Expected Machines Table

NICo needs to know the factory default credentials for each BMC, which is expressed as a JSON table of "Expected Machines". The serial number is used to verify the BMC MAC matches the actual serial number of the chassis.

Prepare an expected_machines.json file as follows:

{
  "expected_machines": [
    {
      "bmc_mac_address": "C4:5A:B1:C8:38:0D",
      "bmc_username": "root",
      "bmc_password": "default-password1",
      "chassis_serial_number": "SERIAL-1"
    },
    {
      "bmc_mac_address": "C4:5A:FF:FF:FF:FF",
      "bmc_username": "root",
      "bmc_password": "default-password2",
      "chassis_serial_number": "SERIAL-2"
    }
  ]
}

Only servers listed in this table will be ingested, so you must include all servers in this file.

When the file is ready, upload it to the site with the following command:

admin-cli -c <api-url> credential em replace-all --filename expected_machines.json

Approve all Machines for Ingestion

NICo uses Measured Boot using the on-host Trusted Platform Module (TPM) v2.0 to enforce cryptographic identity of the host hardware and firmware. The following command configures NICo to approve all pending machines based on PCR Registers 0, 3, 5, and 6.

admin-cli -c <api-url> mb site trusted-machine approve \* persist --pcr-registers="0,3,5,6"